
3 / 8
Hardware Specification
The Atmel® SAM9G and SAM9X embedded MPUs are high-performance, highly integrated processors built the
good foundation of the Atmel® ARM926-based embedded MPU line. Running at 400 MHz, they are designed to
complement the power of the ARM926 core; these flexible devices deliver a rich combination of peripherals
including up to two Ethernet, two CAN, three USB ports and seven UARTS. Additional features include an
integrated soft modem, TFT LCD controller and LPDDR/DDR2 memory support. A multilayer bus matrix
architecture and multiple DMA channels ensure uninterrupted data transfer with minimum processor
intervention. Low voltage, low power consumption and reduced system cost make these devices ideal for
cost-sensitive machine-to-machine applications.
The MYD-SAM9X5 series development boards include one CPU module mounted on one base board. It takes full
features of the Atmel SAM9G and SAM9X processors and is characterized as in below table 1-2:
Figure 1-3 Base Board of MYD-SAM9X5
Figure 1-4 MYC-SAM9X5 CPU Module
Controller Board of MYD-SAM9X5
- 400MHz Atmel AT91SAM9G15, 9G25, 9G35, 9X25 and 9X35 ARM926EJ-S Processors
- CPU internal 32KB of SRAM and 64KB of ROM
- On-board 128MB DDR2 SDRAM, 256MB Nand Flash, 4MB Data Flash, 64KB EEPROM
- On-board Ethernet PHY
- 1.8V DDR2 SO-DIMM 200-pin Expansion Connector
- Fully Compatible with Atmel's SAM9X5-EK Official Board
CPU Module – 67.6 x 35mm; Base board – 140 x 108mm
CPU Module – 8-layer design; Base board – 4-layer design
0~70 Celsius (commercial grade) or -40~85 Celsius (industrial grade)
One 3-line RS232 Debug serial port (DB-9)
One 5-line RS232 serial port (UART0, multiplexed with RS485, DB-9)
Kommentare zu diesen Handbüchern